Resetting Standard Stop Combinations General Crescendo; General Crescendo System With 7-Segment Display - Johannus Monarke User Manual

Resetting standard stop combinations general crescendo

It is always possible to restore the standard stop combinations of a programmable general
crescendo pedal into the general crescendo memory. However, this is only possible for all
the general crescendo steps together. The selected personal stop combinations will be
lost.

General crescendo system with 7-segment display

The standard stop combinations of a general crescendo system with 7-segment display
can be restored as follows:
1. 'Open' the general crescendo memory by turning key switch MEMORY LOCK a quarter
of a turn to the right. The SET-piston will light up, as a sign that the general crescendo
memory is 'open'.
2. Press the thumb pistons GC and PG(M). The display will now show a 0 (step 0, or all
the stops of the general crescendo off). All the stops will now be switched off. Changing
the position of the general crescendo pedal will have no effect.
3. Press the 0-piston (keep pressing it) and then press the SET-piston. The display willl
briefly show the letter P, as a sign that the standard stop combinations are being
restored (programmed) into the general crescendo memory.
4. First release the SET-piston and only then the 0-piston.
5. 'Close' the general crescendo memory by turning key switch MEMORY LOCK a quarter
of a turn to the left (taking the key from the switch, if necessary). The lamp in the SET-
piston will go off now, as a sign that the general crescendo memory is 'closed' again.
6. Again press the PG(M)-piston. The general crescendo is now ready for normal use
again.
User's Manual
0
p 0
JOHANNUS JOHANNUS
JOHANNUS JOHANNUS
48
Monarke