General-Crescendosystem With Lcd - Johannus Monarke User Manual

General-crescendosystem with LCD

A stop combination of a general crescendo system with LCD can be changed as follows
1. 'Open' the general crescendo memory by turning key switch MEMORY LOCK a quarter
of a turn to the right. The SET-piston will now light up as a sign that the general
crescendo memory is 'open'.
2. Press the thumb pistons GC and PG(M). The display will now show a 0 (step 0, or all
the stops of the general crescendo off).
M e m :
T r a n s :
All the stops will now be switched off. Changing the position of the general crescendo
pedal will have no effect.
3. Select the general crescendo step whose stop combination you wish to change by
pressing once or several times the – or the + piston until the display shows the step to
be changed (e.g. step 5).
M e m :
T r a n s :
The stops forming part of the stop combination of the general crescendo step
concerned, will light up.
4. Set the required registration for the step in question (in this example step 5) of the
general crescendo as you wish to store it into the general crescendo memory.
5. Briefly press the SET-piston. The display will, just for a second, show the letter P as a
sign that the selected registration is being programmed into the general crescendo
memory.
M e m : P 6
T r a n s :
6. 'Close' the general crescendo memory by turning key switch MEMORY LOCK a quarter
of a turn to the left (taking the key from the switch, if necessary). The lamp in the SET-
piston will go off now as a sign that the general crescendo memory is 'closed' again.
7. Press again the PG(M)-piston. The general crescendo is ready for normal use again.
User's Manual
1 V o l : 1 2 T u n e : 4 4 0
0 C r e s c e n d o :
1 V o l : 1 2 T u n e : 4 4 0
0 C r e s c e n d o :
V o l : 1 2 T u n e : 4 4 0
0 C r e s c e n d o :
JOHANNUS JOHANNUS JOHANNUS JOHANNUS
47
0
5
5
Monarke