Changing Stop Combinations General Crescendo; General Crescendo System With 7-Segment Display - Johannus Monarke User Manual

Changing stop combinations general crescendo

Items for programming the general crescendo are:
! Thumb pistons GC and PG(M)
! Display
! General crescendo pedal
! Key switch MEMORY LOCK
! Thumb pistons – and +
! SET-piston

General crescendo system with 7-segment display

A stop combination of a general crescendo system with a 7-segment display can be
changed as follows:
1. 'Open' the general crescendo memory by turning key switch MEMORY LOCK a quarter
of a turn to the right. The SET-piston will now light up as a sign that the general
crescendo memory is 'open'.
2. Press the thumb pistons GC and PG(M). The display will now show an 0 (step 0, or all
the stops of the general crescendo off).
3. All the stops will now be switched off. Changing the position of the general crescendo
pedal will have no effect.
4. Select the general crescendo step whose stop combination has to be changed by
pressing the – or the + piston once or several times until the display shows the step that
will be changed (e.g. step 5). The stops belonging to the stop combination of the
general crescendo step in question will light up.
5. Set the required registration for the step (in this example step 5) of the general
crescendo just as it has to be stored into the general crescendo memory.
6. Briefly press the SET-piston. The display will briefly show the letter P as a sign that the
selected registration is being programmed into the general crescendo memory.
7. 'Close' the general crescendo memory by turning key switch MEMORY LOCK a quarter
of a turn to the left (taking the key from the switch, if necessary). The lamp in the
SET-piston will go off now as a sign that the general crescendo memory is 'closed'
again.
8. Press again the PG(M)-piston. The general crescendo can again be used normally.
User's Manual
0
p 6
JOHANNUS JOHANNUS
JOHANNUS JOHANNUS
46
Monarke