Crescendo Pedal - Johannus LiVE III AGO User Manual

Programming a capture memory location:
The current setting of the capture memory location will be lost.
1. Select the desired stops (for a selected Sample bank: ORGAN 1 – 5).
2. Use the - and + pistons to select the desired capture memory level (1-50) on
the display.
3. Press the SET-piston. Hold down this piston (to enable the storage function)
4. Press the desired memory location (1-8).
5. Release the SET-piston.
Calling up a capture memory location:
1. Use the - and + pistons to select the desired capture memory level (1-50) on
the display.
2. Press the desired memory location (1-8).
By holding down the - and + pistons for longer,
the capture memory steps (1-50) can be scrolled more quickly.
With the SEQ-piston a sequential step-by-step, previous or next, memory
locations (1–8) can be selected:
- Pressing a piston of the capture memory locations Pedal will select the previous
General memory location.
- Pressing a piston of the capture memory locations General will select the next
General memory location.
The illuminated memory SEQ-piston together with the capture memory level
(shown in the display) indicate the selected location.
While the sequence function is active (by illuminated memory SEQ-piston), the
normal function of the capture memory locations pistons is disabled.

Crescendo pedal

The crescendo pedal can be used to activate 20 registrations step-by-step. These
registrations start with very quiet (pianissimo) to very loud (tutti).
The default registrations of the 20 steps can be changed. See §5.5.1 Crescendo.
Activating the crescendo pedal
If the crescendo pedal is not activated it is
indicated on the displays with Cresc:Off.
User Manual LiVE III AGO
Utrecht, Bätz
Location Organ Console
───────────────────────────
Mem : 1 █
Trans : -1 █
Tune : 406,8Hz █
Temp : Original █
Cresc : Off I/II/Pd
█
█
█
█
III
24