Table of Contents
Advertisement
Manually operated headlight
The headlight has a push button with three positions: ON – ON [50%] –
OFF.
Adjust the angle of the headlight so that the center of the light beam is
approximately ten meters in front of the bicycle.
The headlight works with batteries. When the batteries are low, a red
LED button lights up where the headlight's push buttons are. Follow
the steps below to replace the batteries.
1.
Open the lamp by pressing down on the lip of the housing
and pulling the front of the lamp off.
2.
Replace the two alkaline batteries (2x AA).
3.
Reassemble the lamp by first pressing the top into the
housing and then snapping the bottom back into place
behind the lip.
Only operate the lighting when stationary to avoid dangerous situations and
the risk of injury.
.
Version 24.01
16/51
Advertisement
Table of Contents
