Table of Contents
Advertisement
6.
Put the front wheel in a straight
position and use a spanner to tighten
the bolt of the steering rod [A].
The front on the frame may not be extended further than the marker [F]. If
this is not observed, the inner tube does not reach far enough into the outer
tube.
Note that after extending the frame, while tightening the frame clips, these
clips are positioned at least 1 cm from the end of the tube. A good indication
for this is if the sticker marker [E] is fully visible.
Setting the chain tension of the front chain (Easy Sport and Easy Sport Smal)
In order to extend the bike further or to alter the position of the derailleur, the chain
tensioners [B] can be moved. Follow these steps:
1.
Loosen the bolt of the chain tensioner [A].
2.
Re-position the chain tensioner [B] to reach the desired tension.
3.
Now tighten the bolt [A] back up.
In order to extend the bike to it's maximum length, the chain most likely has to be
extended by a dealer. When your bike is fitted with a fixed gear or a back-pedal-break, it
may also be needed for you to extend or shorten the chain in order to reach the desired
frame length. In the chapter 'Repairs and mantenance by dealers' more information can
be found. The chain tensioner [B] described above can then be used in order to set the
chain to the desired tension.
Version 24.01
[A] [B]
12/51
Advertisement
Table of Contents
