9: Menu; 10: Resetting The Device To Factory Defaults - FIBARO ROLLER SHUTTER 4 Operating Manual

22
9: Menu
Menu allows to perform actions. In order to use the menu:
1. Switch off the mains voltage (disable the fuse).
2. Remove the device from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the PROG button to enter the menu.
5. Wait for the LED to indicate the desired menu position with colour:
• BLUE - autocalibration
• YELLOW - factory reset
6. Quickly release and click the PROG button again.
7. After clicking the PROG button, the LED indicator will confirm the
menu position by blinking.
menu
10: Resetting the device to factory
defaults
Resetting the device to factory defaults:
Reset procedure allows to restore the device back to its factory
settings, which means all information about the Z-Wave controller
and user configuration will be deleted.
Please use this procedure only when the network primary controller
is missing or otherwise inoperable.
1. Switch off the mains voltage (disable the fuse).
2. Remove the device from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the PROG button to enter the menu.
5. Wait for the LED indicator to glow yellow.
6. Quickly release and click the PROG button again.
7. During the factory reset, the LED indicator will blink yellow.
8. After few seconds the device will be restarted, which is signalled
with the red LED indicator colour.
resettIng tHe DevIce to factory Defaults
23