5: Adding To Z-Wave; Tm Network; Adding Manually - FIBARO ROLLER SHUTTER 4 Operating Manual

8
4.2: Installation
1. Switch off the mains voltage (disable the fuse).
i
NOTE
2. Open the wall switch box.
If you are using
yubii Home, Hc3l
3. Connect with the following diagram.
or Hc3 Hub, you
don't have to
PE
concern about
connecting the
L
directions cor-
rectly. you can
N
change the direc-
tions in the the
wizzard and de-
vice settings in
the mobile app.
i
NOTE
to connect ex-
ternal switch/
switches use
supplied jumper
wires if necessary.
N
Wiring diagram – connection with AC motor
4. Verify if the device is connected correctly.
5. Arrange the device in a wall switch box.
6. Close the wall switch box.
7. Switch on the mains voltage.
InstallatIon
5: Adding to Z-Wave network
TM
Adding (Inclusion) – Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
5.1: Adding manually
To add the device to the Z-Wave network manually:
1. Power the device.
2. Identify the PROG button or the S1/S2 switches.
3. Set the main controller in (Security/non-Security Mode) add
mode (see the controller's manual).
4. Quickly, click PROG button three times. Optionally, click S1 or S2
three times.
5. If you are adding in Security S2 Authenticated, input the PIN
Code (label on the device, also underlined part of the DSK on the
label on the bottom of the box).
6. Wait for the LED indicator to blink yellow.
7. Successful adding will be confirmed by the Z-Wave controller's
message and the device's LED indicator:
• Green – successful (non-secure, S0, S2 non-authenticated),
• Magenta – successful (Security S2 Authenticated),
• Red – not successful.
9
aDDIng to Z-Wavetm netWork