Related Manuals for FIBARO BUTTON
Summary of Contents for FIBARO BUTTON
-
Page 1: Table Of Contents
O P E R A T I N G M A N U A L FIBARO BUTTON FGPB-101 CONTENTS v1.1 #1: Description and features #5: Associations #2: Basic activation #6: Advanced parameters #3: Adding/removing the device #7: Specifications #4: Operating the device... - Page 2 General information about the FIBARO System FIBARO is a wireless smart home automation system, based on the Z-Wave protocol. All of available devices can be controlled through a computer (PC or Mac), smartphone or tablet. Z-Wave devices are not only receivers, but can also repeat the signal, increasing the Z-Wave network’s range.
-
Page 3: 1: Description And Features
Z-Wave network and run various scenes defined in FIBARO System. Different actions may be triggered with one to five clicks or by holding the button down. In panic mode, each press of the button results in triggering the FIBARO Alarm. -
Page 4: 3: Adding/Removing The Device
To add the device to the Z-Wave network: fault) and/or trigger a scene Mode must be per- formed up to 2 meters 1. Place the Button within the direct range of your Z-Wave controller. 2 clicks: send action to associated devices (switch on maximum from the controller. -
Page 5: 5: Associations
GET commands and frequent communica- The Button will wake up at each defined time interval and always try to will not respond with a tion and thus a longer connect with the main controller. After successful communication at- Basic Report. - Page 6 3. Associations in Z-Wave network Security Mode 14. Key Pressed 3 times – command sent to 2nd association group NOTE This parameter defines how commands are sent in specified associa- This parameter defines commands sent to devices associated in 2nd values of parameter tion groups: as secure or non-secure.
-
Page 7: 7: Specifications
This parameter defines commands sent to devices associated in 3rd (diameter x height): (1.81" x 1.34") association group after holding the button down. Available settings: 0 - no action 1 - START LEvEL ChAnGE uP (brightening) 2 - START LEvEL ChAnGE DOWn (dimming) 3 - START LEvEL ChAnGE uP/DOWn (brighten- ing/dimming) –... -
Page 8: 8: Regulations
Consult the dealer or an experienced radio/Tv technician for help. Declaration of conformity Industry Canada (IC) Compliance Notice hereby, Fibar Group S.A. declares that FIBARO Button is in compliance This device complies with Industry Canada license-exempt RSSs. Oper- with the essential requirements and other relevant provisions of Di- ation is subject to the following two conditions: (1) this device may not rective 1999/5/EC.
Need help?
Do you have a question about the BUTTON and is the answer not in the manual?
Questions and answers