Table of Contents
Advertisement
6
REMOVING FROM Z-WAVE NETWORK
Removing (Exclusion) – Z-Wave device learning mode, allowing to remove the device from existing Z-Wave network.
To remove the device from the Z-Wave network:
1.
Make sure the device is powered.
2.
Identify the PROG button or the S1/S2 switches.
3.
Set the main controller in remove mode (see the controller's manual).
4.
Quickly, click PROG button three times. Optionally, click S1 or S2 three times within 10 minutes of powering up the device.
5.
Wait for the removing process to end.
6.
Successful removing will be confirmed by the Z-Wave controller's message and the device's LED indicator - Red.
7.
Removing the device from the Z-Wave network doesn't cause factory reset.
7
CALIBRATION
Calibration is a process during which a device learns the position of the limit switches and a motor characteristic.
Calibration is mandatory in order for the device to correctly recognize a roller blind position.
The procedure consists of an automatic, full movement between the limit switches (up, down, and up again).
Automatic calibration using the menu
1.
Press and hold PROG button to enter the menu.
2.
Release button when the device glows blue.
3.
Quickly click the button to confirm.
4.
The device will perform the calibration process, completing full cycle – up, down and up again. During the calibration the LED blinks blue.
5.
If the calibration is successful, the LED indicator will glow green, if the calibration is failed, the LED indicator will glow red.
6.
Test whether the positioning works correctly.
Automatic calibration using the parameter
1.
Set parameter 150 to 3.
2.
The device will perform the calibration process, completing full cycle – up, down and up again. During the calibration the LED blinks blue.
3.
If the calibration is successful, the LED indicator will glow green, if the calibration is failed, the LED indicator will glow red.
4.
Test whether the positioning works correctly.
Note:
If you are using yubii Home, HC3L or HC3 Hub, you can perform calibration from the wizard or device settings in the mobile app.
Note:
You can stop the calibration process at any moment by clicking prog button or external keys.
Note:
If the calibration is failed, you can manually set times of up and down movements (parameters 156 and 157).
Manual positioning of slats in venetian blinds mode
1.
Set parameter 151 to 1 (90°) or 2 (180°), depending on the rotation capability of the slats.
2.
By default, time of transition between extreme positions is set to 15 (1.5 seconds) in parameter 152.
3.
Turn slats between extreme positions using
•
If after full cycle a blind starts moving up or down - decrease value of parameter 152,
•
If after full cycle the slats does not reach end positions - increase value of parameter 152,
4.
Repeat previous step until satisfactory positioning is achieved.
5.
Test whether the positioning works correctly. Correctly configured slats should not force the blinds to move up or down.
or
switch:
Advertisement
Table of Contents
