Table of Contents
Advertisement
Altering capabilities
NICE Roll-Control2 uses different set of Window Covering Parameter IDs depending on the values of the 2 parameters:
Calibration status (parameter 150),
Operating mode (parameter 151).
Altering capabilities
Calibration status
(parameter 150)
0 - Device is not calibrated
or
2 - Autocalibration failed
0 - Device is not calibrated
or
2 - Autocalibration failed
1 - Autocalibration successful
or
4 - Manual calibration
1 - Autocalibration successful
or
4 - Manual calibration
If any of the parameters 150 or 151 changes, the controller should perform rediscovery procedure
in order to update the set of Supported Window Covering Parameter IDs.
If the controller does not have any capability rediscovery option, it is necessary to re-include the node in the network.
Association Group Information CC
Protection CC
Group
Profile
General: Lifeline
1
(0x00: 0x01)
Control: KEY01
2
(0x20: 0x01)
Operating mode
Supported Window Covering Parameter IDs
(parameter 151)
0 – Roller blind,
Awning, Pergola,
Curtain
1 – Venetian blind
90° or
2 – Roller blind with
built-in driver 180°
0 – Roller blind,
Awning, Pergola,
Curtain
1 – Venetian blind
90° or
2 – Roller blind with
built-in driver 180°
Command Class & Command
DEVICE_RESET_LOCALLY_NOTIFICATION [0x5A 0x01]
NOTIFICATION_REPORT [0x71 0x05]
SWITCH_MULTILEVEL_REPORT [0x26 0x03]
WINDOW_COVERING_REPORT [0x6A 0x04]
CONFIGURATION_REPORT [0x70 0x06]
INDICATOR_REPORT [0x87 0x03]
METER_REPORT [0x32 0x02]
CENTRAL_SCENE_CONFIGURATION_ REPORT [0x5B 0x06]
WINDOW_COVERING_SET [0x6A 0x05]
WINDOW_COVERING_START_LVL_ CHANGE [0x6A 0x06]
WINDOW_COVERING_STOP_LVL_ CHANGE [0x6A 0x07]
out_bottom (0x0C)
out_bottom (0x0C)
Horizontal slats angle (0x16)
out_bottom (0x0D)
out_bottom (0x0D)
Horizontal slats angle (0x17)
Group Name
Lifeline
Window Covering
Advertisement
Table of Contents
