Table of Contents
Advertisement
Parameter:
41. Second button – scenes sent
Description:
This parameter determines which actions result in sending scene IDs assigned to them.
Values can be combined (e.g. 1+2=3 means that scenes for single and double click are sent).
Enabling scenes for triple click disables entering the device in learn mode by triple clicking.
Available settings:
0 - No scene active
1 – Key pressed 1 time
2 – Key pressed 2 times
4 – Key pressed 3 times
8 – Key hold down and key released
Default setting:
15 (All scenes active)
Parameter:
150. Calibration
Description:
To start automatic calibration, select the value 3. When the calibration process is successful, the
parameter takes the value 1. When automatic calibration fails, the parameter takes the value 2.
If the transitions times for the device are changed manually in the parameter (156/157), the param-
eter 150 will takes the value 4.
Available settings:
0 - Device is not calibrated
1 - Autocalibration successful
2 - Autocalibration failed
3 - Calibration process
4 - Manual calibration
Default setting:
0 (default value)
Parameter:
151. Operating mode
Description:
This parameter allows you to adjust the operation, depending on the connected device.
In the case of venetian blinds, the angle of rotation of the slats must also be selected.
Available settings:
0 – Roller blind, Awning, Pergola, Curtain
1 – Venetian blind 90°
2 – Venetian blind 180°
Default setting:
0 (default value)
Parameter:
152. Venetian blind - slats full turn time
Description:
For Venetian blinds the parameter determines time of full turn cycle of the slats.
The parameter is irrelevant for other modes.
Available settings:
0-65535 (0 - 6553.5s, every 0.1s) - time of turn
Default setting:
15 (1.5 seconds)
Parameter:
156. Time of up movement
Description:
This parameter determines the time it takes to reach full opening.
The value is set automatically during the calibration process. It should be manually set in case of
problems with the autocalibration.
Available settings:
0-65535 (0 - 6553.5s, every 0.1s) - time of turn
Default setting:
600 (60 seconds)
Parameter:
157. Time of down movement
Description:
This parameter determines the time it takes to reach full closure.
The value is set automatically during the calibration process.
It should be manually set in case of problems with the autocalibration.
Available settings:
0-65535 (0 - 6553.5s, every 0.1s) - time of turn
Default setting:
600 (60 seconds)
1 [byte]
Parameter size:
Parameter size:
1 [byte]
1 [byte]
Parameter size:
Parameter size:
2 [byte]
Parameter size:
2 [byte]
Parameter size:
2 [byte]
Advertisement
Table of Contents
