Table of Contents
Advertisement
Basic CC
Basic CC
Command
Basic Set
Basic Set
Basic Set
Basic Get
Basic Report
(Current Value and Target Value
MUST be set to 0xFE if not position aware.)
Notification CC
The device uses Notification Command Class to report different events to the controller ("Lifeline" Group).
Notification CC
Notification Type
Power Management [0x08]
System [0x09]
Protection CC
Protection Command Class allows to prevent local or remote control of the outputs.
Protection CC
Type
State
Local
0
No operation possible – button can not change relay state,
Local
2
RF
0
Unprotected - The device accept and respond to all RF Commands.
No RF control – command class basic and switch binary are rejected, every
RF
1
Meter CC
Meter CC
Meter Type
Electric [0x01]
Electric_kWh [0x00]
[0x00] to [0x63]
Over-current detected [0x06]
System hardware failure
with manufacturer proprietary
failure code [0x03]
Description
Unprotected - The device is not protected,
and may be operated normally via the user interface.
any other functionality is available (menu).
other command class will be handled.
Scale
Rate Type
Import [0x01]
Value
Mapping command
[0xFF]
Multilevel Switch Set
[0x00]
Multilevel Switch Set
Start Level Change
(Up/Down)
Multilevel Switch Get
Multilevel Switch
Report
Event / State
Idle [0x00]
Idle [0x00]
MP code: 0x01
[device overheat]
Precision
1
Mapping value
[0xFF]
Multilevel Switch Set
[0x00], [0x63]
Parameter
Status
0xFF – enable
(nonchangeable)
0xFF – enable
(nonchangeable)
Buttons connected with outputs.
Buttons disconnected from outputs.
Outputs can be controlled via Z-Wave.
Outputs cannot be controlled via Z-Wave.
Size
4
In endpoints
Root
Root
Hint
Advertisement
Table of Contents
