Function Of Each Part - OREC SNOW RHINO Owner's Manual

2.2

Function of each part

1. Ignition Key Switch
Use this switch when you start / stop the engine. Insert the key and turn it [Start] position to start
the engine. It runs the machines when in [ ON ] position, and stops the engine when in [OFF] position.
2. Throttle Lever
Move the throttle lever to adjust the engine RPM . Use it to adjust the speed of driving and the
pressure of pushing snow.
Move to [
Move to [
3. Choke Lever
Use this when starting the engine in cold temperatures. Move the lever to [CLOSE] position, start the
machine, then move it to [OPEN] position when the engine is warmed up.
4. Fuel valve
Close fuel line. Turn the lever to [OPEN] position when start the engine, turn it to [CLOSE] position after you
use the machine. Always close the fuel valve when transport ing machine.
5. Main Clutch/Parking Lever
Engage/disengage the power from the engine. When pull ed back, disengage the engine and engage the
parking brake. When push forward, engage the engine and disengage the parking brake.
6. Control lever L / 7. control lever R
Use these levers to control each track speed. The left lever controls the left track, the right lever controls the
right track. By tiling these levers, it increases and decreases speed. Tilting forward moves the track forward,
tilting backward moves the track reverse .
8. High-Low Range Lever
Choose high range gear and low range gear in the transmission. Low range on the right, High range on the left
side. Neutral (free wheel) when in the middle position.
9. Plow blade height adjust lever
Change the plow blade height depend ing on the job. The plow blade will get lower by pulling the lever down,
and will get higher when pushing the lever forward.
10. Plow Blade Angle Arm
Set the plow blade angle by moving the arm. The plow blade will angle to the right when the arm is grabbed
and pulled. It will angle to the left when the arm is pushed forward. You can set it at 0, 15, and 30 degree
angles.
11. Platform Release
It will be used to release the locked Platform. To release, hold the platform slightly up then push the lever.
The platform can be locked when fold ed and opened (2 positions).
12. Switch, Head/Rear Lights
Turn on and off both the head light and the rear light. When push ed, the lights will be turned on. The button
will illuminate blue when turned on. It will be turned off when you push it again.
13. Pilot Light (Green)
It illuminates when the key ignition switch is in [ON] position even the engine is not running.
head/rear lights and the plow blade height adjust feature and it consumes battery. When you stop the
machine,
make sure the light is not turned on after turn ing the ignition key off.
14. Oil Light (Red)
It illuminates when the engine oil level gets low. If it turns on, stop the engine immediately and check the engine oil level.
15. Fuse Box
It protects fuses that provide overcurrent protection of an electrical circuit from dust and water. There are 10A
for accessories, 15A for power outlet, 25A for the plow blade height adjustment. When fuse is out, please
assess the cause and replace with a new fuse.
16 Emergency Stop Switch
Stop the machine immediately by pushing the button. When the button is turned to the right, it will be reset.
Please make sure turn the ignition key is switched to [OFF] otherwise the battery will die.
] for lower engine RPM
] for higher engine RPM
--9--
You can use the