Troubleshoot - OREC SNOW RHINO Owner's Manual

7.3

Troubleshoot

If any of the following issues occur, refer to the instruction manual and take the appropriate action.
Effect
No response.
Belt slips.
Tracks slip.
Does not
drive.
An overload
Does not stop。 Slightly move
Do not move
up/down
Blade won't
move
Do not angle.
Starter won't start
Engine does not
start.
Do not start
Engine does not stop.
If you do not understand any of these points, please consult with the retailer where you purchased
this machine.
Possible cause
Main clutch is not in work position.
High-Low range lever is in neutral.
Belt is stretched.
Belt is worn out.
Jammed foreign material in the track.
Too much amount of snow for one time.
Being caught in something
Plow Blade is set too low
Crawler is stretched.
Too fast for operation.
Engine rpm is too low.
Too fast for operation.
Foreign object twined around tracks.
Too much amount of snow for one time.
Wet and heavy snow.
Insufficient HST oil
Failure of transmission.
Control lever won't move smoothly
The lever is not in neutral position
Fuse is out.
Blade is caught
The Hydraulic actuator is broken
Blade is caught.
The pivot pin or cable is rusted
Clutch lever is not in PARKING position
Emergency switch is ON
Safety sensor is nor working
Failure of engine switch
Harness came off or is damaged.
--37--
Treatment
Move the lever to owrk
Put it in Low or High
Adjust the tension of belt.
Replace belt.
Remove foreign material.
Remove snow in several times.
Remove obstacle or raise plow.
Raise the blade height
Adjust the tension.
Reduce the speed for operation.
Adjust the engine rpm.
Reduce the speed for operation.
Remove twining object.
Remove snow in several times.
Remove snow in several times.
Add HST oil
Repair or replace transmission.
Lubricate
Adjust the adjuster.
Replace fuse
Remove obstacles.
Replace with new
Repair or replace transmission.
Lubricate
Put the main clutch lever in Parking
Off the emergency switch
Check if it is pressed or replace it.
Replace engine speed.
Repair harness.