Long Term Storage - OREC SNOW RHINO Owner's Manual

5.4

Long term storage

5.4.1 Fuel
If you do not plan to use the machine for more than 30 days, please follow these procedures for proper
storage. If the machine is not stored properly, gasoline can spoil causing damage to the engine; it may
fail to start, or you may have difficulty running the machine.
DANGER
・ Please perform maintenance in a place that is well ventilated. Gas fumes can fill a room and cause
illness or accidents.
・ Before working on the machine, switch off the engine and remove the spark plug cord.
・ Store the machine on a flat surface in a place protected from the elements and is well ventilated
and cool.
・ When removing fuel, do not work near lit cigarettes or other sources of open flame. Also, keep
fireworks and firearms away as there is a danger of the machine catchin g fire.
・ When removing fuel, be sure that the engine and muffler have cooled before touching the machine.
There is a danger of burns. Take care to dispose of fuel in accordance with local laws and
regulations.
5.4.2 The following should be performed before the next operation
・ Always use fresh fuel.
・ Inspect the machine before operation.
・ Check that all functions work.
・ Check any abnormal noise or heat by working a little bit.
・ Do not overwork for the first 2 -3 hours to break in the machine.
・ Check that all bolts and nuts are tightened properly.
・ Check for any leaks and repair accordingly.
*If you see any traces of oil, contact your dealer before operatio n.
Battery Type ---U1R type, 12V 270CCA or greater (Not included)
1.Empty fuel from inside the fuel tank and the carburetor. To remove
fuel from inside the carburetor, remove the drain screw from
underneath and allow any fuel to flow into an approved container.
2.Clean away any fuel on the outside of the engine or machine with a
rag.
3.Please replace the engine oil. Refer to [ Replacing Engine Oil ]
4.Wash all parts well.
- Clean the recoil starter, air filter, muffler, around the carburetor, and
inside the belt cover by blowing air through them to remove dirt and dust.
- Remove rust from affected areas and apply anti-corrosion paint.
- If you continue to operate with an accumulation of grass and dust in the
machine, the engine can become clogged, causing it to overheat and
possibly catch fire.
5.Refuel and lubricate the necessary parts and have any defective p arts
repaired
6.Cover the machine to keep dust out.
--31--
: