OREC SNOW RHINO Owner's Manual page 22

WARNING
To avoid damage, accidents, or injury, be sure to follow all instructions below, regarding
loading and unloading the machine.
・ When loading into a vehicle/trailer choose appropriate size (capacity and size) , be sure to check
the area around you, and choose a flat surface for stability. Use parking brake for safety.
・ Use a ramp properly designed for the job. Be sure it is wide and sturdy enough and that the
machine stays in the middle of the ramp. Always walk behind the machine and use the lowest
speed to load. Use reverse to unload.
・ Do not change speed while you are loading or unloading, and unload slowly.
・ Make sure you are using the parking brake for transport. Secure the machine with strong straps
during transportation.
・ When loading the machine, secure it with steady straps and take care not to damage cables or
plastic parts of the machine . Do not secure it so tightly that you change the shape of any parts.
4.4.1 Loading/unloading
Loading
Slow with blade raised
Notes: Ramps requirements.
Length- more than 3.5 times longer than trailer height.
Width- Wider than track width.
Weight limit - strong enough for machine weight and operator 's weight.
Surface – nonslip surface
Secure – securely set with trailer bed.
1.Choose flat safe place for loading
2.Make sure the ramps are securely set
3.While loading, raise the plow so that it doesn't
touch the ramp. Set the tracks in the middle of the
ramps.
4.Always walk behind the machine and use the
lowest speed to load, and reverse to unload.
--22--