Table of Contents
Advertisement
FROM TRANSPORT MODE TO EXCAVATION MODE
1 Remove the transport locking devices for the lifting boom and rotation, see page 20.
2 Start the engine on the backhoe digger according to the instructions in the manual.
3. Now rotate the machine to the right and left respectively, using the digger arm to lift/tilt
the backhoe digger .
4. Then fit the stabilisers on the right- and left-hand sides respectively, see page 16.
5. Now rotate back towards the wheel side and extend the digger arm to release the pressure
by the tow ball in order to disengage.
6. Now push in the tow bar, see page 16.
7. The backhoe digger is now ready for use
NOTE: Always dig on the side of the stabiliser in order to avoid damage to the wheel axles.
FROM EXCAVATION MODE TO TRANSPORT MODE
Repeat the above points in reverse order from excavation mode to transport mode.
It is important to fit the transport locking devices to avoid uncontrolled movements.
Drive slowly on uneven terrain, do not drive too close to sloping terrain and large holes.
Transport locking device.
Swing/rotation
Digger arm
20
Table of Contents
Advertisement
Table of Contents
