Simple Network Management Protocol (Snmp) Settings; Date And Time Settings - Digi Connect Series User Manual

Configure the device using the web interface

Simple Network Management Protocol (SNMP) Settings

Use the Simple Network Management Protocol (SNMP) Settings page to manage and monitor network
devices. You can configure Digi Connect and ConnectPort TS Family devices to use SNMP features, or
you can disable SNMP for security reasons. For additional information, see
Management Protocol
n
Enable Simple Network Management Protocol (SNMP): This check box enables or disables
use of SNMP.
The Public community and Private community fields specify passwords required to get
l
or set SNMP-managed objects. Changing public and private community names from their
defaults is recommended to prevent unauthorized access to the device.
Public community: The password required to get SNMP-managed objects. The default is
l
public.
Private community: The password required to set SNMP-managed objects. The default is
l
private.
Allow SNMP clients to set device settings through SNMP: This check box enables or
l
disables the capability for users to issue SNMP set commands uses use of SNMP read-only
for the Digi device.
n
Enable Simple Network Management Protocol (SNMP) traps: Enables or disables the
generation of SNMP traps.
Trap Destinations: Provide the IP address or fully qualified domain name (FQDN) of the
l
system where the SNMP agent sends traps. The primary destination is required. The
secondary destination is optional.
Primary/Secondary: The IP address of the system to which the SNMP agent sends traps.
l
To enable any of the traps, you must specify a non-zero value. The primary destination is
required. The secondary destination is optional. If your Digi devices supports alarms, you
must complete this field in order to send alarms in the form of SNMP traps. See
Configuration.
You can use the following SNMP trap check boxes:
Generate authentication failure traps: The SNMP agent will send SNMP authentication
l
traps when there are authentication failures.
Generate login traps: The SNMP agent sends SNMP login traps on login attempts.
l
Generate cold start traps: The SNMP agent sends traps on cold starts of the Digi device.
l
Generate link up traps: The SNMP agent sends link up traps when network connections
l
are established.

Date and Time Settings

Use the Date and Time Settings page to set the Coordinated Universal Time (UTC) and/or system time
and date on a device, or set the offset from UTCfor the Digi device's system time.
Digi Connect Family and ConnectPort TSFamily
(SNMP).
System Configuration
Simple Network
Alarms
101