Rf Exposure Statement; Fcccertifications And Regulatory Information (Usa Only) - Digi Connect Series User Manual

Specifications and
certifications

RF exposure statement

Digi Connect Wi-SP, Digi Connect Wi-EM, and Digi Connect Wi-ME
The Digi Connect and ConnectPort TS Family wireless devices Digi Connect Wi-SP, Digi Connect Wi-EM,
and Digi Connect Wi-ME comply with the RF exposure limits for humans as called out in RSS-102.
These devices are exempt from RF evaluation based on its operating frequency of 2400 MHz, and
effective radiated power of 100 milliwatts. This would be less than the 3 watt requirement for a
mobile device (>20 cm separation) operating at 2400 MHz.
FCC certifications and regulatory information (USA only)
n
FCCPart 15 Class B
n
Radio Frequency Interface (RFI) (FCC15.105)
n
Labeling Requirements FCC(15.19)
FCC part 15 Class A
These devices comply with part 15 of the FCCrules. Operation is subject to the following two
conditions: (1) These devices may not cause harmful interference, and (2) These devices must accept
any interference received, including interference that may cause harmful operation.
Radio Frequency Interface (RFI) (FCC 15.105)
This device has been tested and found to comply with the limits for Class B digital devices pursuant to
Part 15 Subpart B, of the FCCrules. These limits are designed to provide reasonable protection
against harmful interference in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try and correct the interference by one or more of the following
measures:
n
Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
n
Consult the dealer or an experienced radio/TVtechnician for help.
Labeling Requirements FCC (15.19)
This device complies with Part 15 of FCCrules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
If the FCCID is not visible when installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module FCCID.
Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly approved by Digi may void the user's
authority to operate this equipment.
Digi Connect Family and ConnectPort TSFamily
Digi Connect and ConnectPort TSFamily regulatory information and
certifications
170