Enphase Microinverters Installation; Step 1: Install A Junction Box - enphase IQ8MC Installation And Operation Manual

Enphase microinverters installation

Installing the IQ8 Series Microinverter involves the following 11 key steps. Each step listed here is
detailed in the following pages.

Step 1: Install a junction box.

Step 2: Position the IQ Cable.
Step 3: Terminate the unused end of the IQ Cable.
Step 4: Prepare the AC Modules.
Step 5: Create the installation map.
Step 6: Mount the AC Modules.
Step 7: Connect the microinverters.
Step 8: Manage the cabling.
Step 9: Ground the AC Modules.
Step 10: Energize the system.
Step 11: Set up and activate monitoring.
Step 1: Install a junction box
Verify that the AC voltage at the site is within range.
A.
Single-phase service
L1 to N
B. Install a junction box at a suitable location on the racking.
C. Provide an AC connection from the junction box back to the electricity network using equipment
and practices as required by local jurisdictions.
14
IQ8MC, IQ8AC, and IQ8HC Installation and Operation Manual
184 to 276 VAC
© 2023 Enphase Energy Inc. All rights reserved.
Three-phase service
L1 to L2 to L3
L1, L2, L3 to N
319 to 478 VAC
184 to 276 VAC
November 2023
USM-00006-2.0