Leica GS18 User Manual page 23

Button combinations
User Interface
Button
Button
ON/OFF
+ +
Function
Function
base mode and a position is available, RTK OUT
•
is configured: The RTK base LED flashes green
for 2 s.
The GS18 takes the next available position and
updates the coordinates of the currently stored
RTK base position.
base mode and no position is available, no RTK
•
OUT is configured: No action.
rover mode: No action.
•
Press and hold button for 5 s.
If the GS18 is in:
base mode: No action.
•
rover mode and RTK IN via Internet is con-
•
figured: The RTK rover LED flashes green for 2 s.
The GS18 will connect to the RTK base station
or the Ntrip server configured.
rover mode and RTK IN active and data being
•
received via Internet: The RTK rover LED flashes
green for 2 s. The GS18 will stop the RTK
stream and disconnect to the RTK base station
or (Ntrip) server.
rover mode but RTK in not configured: No
•
action.
Function
Press and hold both buttons, release after 1 s.
The current almanacs stored on the GNSS instru-
ment are deleted and new almanacs are down-
loaded. The Position LED flashes orange quickly
three times.
Press and hold buttons for 5 s.
The Memory LED flashes red quickly three times.
If no SD card is inserted, the internal memory of
the GNSS instrument is formatted. If inserted, the
SD card of the GNSS instrument is formatted. The
Memory LED continues to flash red as the internal
memory or SD card is formatted.
Press and hold buttons for 10 s.
The System RAM on the GNSS instrument is format-
ted. Settings of all installed software will be deleted.
After the formatting the System RAM, the GNSS
instrument is turned off.
Following LEDs flash simultaneously three times:
Position LED: Orange
•
Tilt LED: Red
•
RTK Base and RTK Rover LEDs: Green
•
23