Fronius TransPocket 1100 Operating Instructions Manual page 42

Preventive and
corrective main-
tenance
Safety inspection
Disposal
Safety markings
ud_fr_st_sv_00467 022013
With parts sourced from other suppliers, there is no certainty that these
parts will have been designed and manufactured to cope with the stressing
and safety requirements that will be made of them. Use only original spares
and wearing parts (this also applies to standard parts).
Do not make any alterations, installations or modifications to the machine
without getting permission from the manufacturer first.
Replace immediately any components that are not in perfect condition.
When ordering spare parts, please state the exact designation and the
relevant part number, as given in the spare parts list. Please also quote the
serial number of your machine.
The manufacturer recommends that a safety inspection of the device is
performed at least once every 12 months.
The manufacturer recommends that the power source be calibrated during
the same 12-month period.
A safety inspection should be carried out by a qualified electrician
- after any changes are made
- after any additional parts are installed, or after any conversions
- after repair, care and maintenance has been carried out
- at least every twelve months.
For safety inspections, follow the appropriate national and international
standards and directives.
Further details on safety inspection and calibration can be obtained from
your service centre. They will provide you on request with any documents
you may require.
Do not dispose of this device with normal domestic waste!
To comply with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation as national law, electrical
equipment that has reached the end of its life must be collected separately
and returned to an approved recycling facility Any device that you no longer
require must be returned to our agent, or find out about the approved
collection and recycling facilities in your area.
Ignoring this European Directive may have potentially adverse affects on the
environment and your health!
Equipment with CE-markings fulfils the basic requirements of the Low-
Voltage and Electromagnetic Compatibility Guideline (e.g. relevant product
standards according to EN 60 974). .
Equipment marked with the CSA-Test Mark fulfils the requirements made in
the relevant standards for Canada and the USA.
XII