Edging; Height Adjustment - Peco ZT-5000 Operator's Manual

Trimming (cont.)
To activate trimmer head flip the switch to the ( I )
position. To de-activate the trimmer head flip the switch
to the ( O ) position. Refer to Figure A.
Figure A
Section 4 Height Adjustment
While in the down position, adjust the height of the
trimmer head so that it is in line with the blades on the
mower deck.
Figure C
For fine tuning adjustment of the height, use the
adjustment bolt shown in Figure D. Turn the bolt
clockwise to lower the swing arm, or counter-clockwise
to raise the swing arm.
8
Toggle
Switch
on Position

Height Adjustment

Holes
To position the trimmer head for edging, loosen the
star knob shown in Figure B, rotate the trimmer
head into the position desired for edging and re-
tighten the star knob.
Figure B
Figure D
Adjustment
Bolt

Edging

Star
Knob
Rotate Trimmer
Head