Mounting Instructions; Operating Instructions; Trimming - Peco ZT-5000 Operator's Manual

Section 2 Mounting Instructions
NOTE: The Z-Trimmer Pro is designed to fit most styles
of mowing decks. We recommend using 4 mounting
holes to secure the Z-Trimmer Pro to the mowing deck.
The style of mowing deck on your machine will
determine which mounting holes you will use.
Before drilling any holes into your mowing deck, locate
the best position for the Z-Trimmer Pro. Things you
should consider before drilling any holes:
— Clearance for the Z-Trimmer Pro in both the up and
down positions.
— Accessibility to the handle from the operator's seat.
— Distance between the trimmer head and the mowing
deck when the Z-Trimmer Pro is in the engaged
position.
— Check for possible blade interference.
Place the Z-Trimmer Pro to the side of the mowing deck
opposite of the grass discharge chute. Position the base
plate so that the plate is flush with the edge of the deck
and on center. Once in position, mark four holes from the
base plate onto your mowing deck. Drill the holes with a
1/4" (.250-.257) drill bit. Secure the Z-Trimmer Pro to the
mower deck using (4) 1/4"-20 x 1" Hex Bolts P#(K1125)
and (4) 1/4"-20 Nylon Flange Locknuts P#(K2014).
Refer to Figure A and B.
Route the power cable before connecting the cable to the battery. After the Z-trimmer Pro has been secured to the
mowing deck route the cable around the outside of the operator seat so that the cable does not interfere with the seat
or the control arms. Before connecting the power cable to the battery ensure the power switch is in the off position.
Keep cable away from all heat sources and moving parts. Use zip-ties to secure the power cable, once the best
routing has been determined.
Section 3 Operating Instructions
When not in use the Z-Trimmer Pro should be in the
upright position with the latch hook secured. See Figure
A.
Figure A
Latch Hook
Secured
1. Release the latch hook and lower the trimmer into the
down position. Refer to Figure B.
Latch
Hook
Figure A
Mark and Drill
Holes
Base Plate
Mower Deck
Edge
Figure B
Edge of
Mowing Deck

Trimming

Figure B
Mark and Drill
Holes
Base Plate
Lower Trimmer
Into Position
Release
Latch Hook
7