Appendix A: Iec60601-1-2 Emc Tables; Guidance And Manufacturer's Declaration - Electromagnetic Emissions; Guidance And Manufacturer's Declaration - Electromagnetic Immunity - F&P SleepStyle Auto Technical Manual

APPENDIX A: IEC60601-1-2 EMC TABLES

GUIDANCE AND MANUFACTURER'S DECLARATION - ELECTROMAGNETIC EMISSIONS

The F&P SleepStyle Series is intended for use in the electromagnetic environment specified below. The customer or the user of the F&P
SleepStyle Series should ensure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations flicker
emissions
IEC 61000-3-3

GUIDANCE AND MANUFACTURER'S DECLARATION - ELECTROMAGNETIC IMMUNITY

The F&P SleepStyle Series is intended for use in the electromagnetic environment specified below. The customer or the user of F&P SleepStyle
Series should ensure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD)
IEC61000-4-2
Electrical fast transient/
burst
IEC61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power
supply input lines
IEC 61000-4-11
Power frequency (50/60
Hz)/ magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to the application of the test level.
Compliance Electromagnetic environment - guidance
Group 1 The device uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
Class B The device is suitable for use in all establishments, including domestic establishments
and those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Class A
Complies
IEC60601 test level
± 8 kV contact
± 15 kV air
± 2 kV for power supply lines
± 1 kV line to line
< 5 % UT (>95 % dip in UT) for 0.5 cycle
40 % UT (60 % dip in UT) for 5 cycles
70 % UT (30 % dip in UT) for 25 cycles
< 5 % UT (>95 % dip in UT) for 5 sec
30 A/m
Compliance level
± 8 kV contact
± 15 kV air
± 2 kV
± 1 kV
< 5 % UT (>95 % dip in UT) for 0.5 cycle
40 % UT (60 % dip in UT) for 5 cycles
70 % UT (30 % dip in UT) for 25 cycles
< 5 % UT (>95 % dip in UT) for 5 sec
30 A/m
Electromagnetic environment -
guidance
Floors should be wood, concrete
or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should be at
least 30 %.
Mains power quality should
be that of a typical residential,
commercial or professional
healthcare facility environment.
Mains power quality should
be that of a typical residential,
commercial or professional
healthcare facility environment.
Mains power quality should
be that of a typical residential,
commercial or professional
healthcare facility environment.
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
residential, commercial or
professional healthcare facility
environment.
F&P SleepStyle Product Technical Guide | 11