S-And Tx Power Meter Symbols - Yaesu VX-7R Operating Manual

D C
ISPLAY USTOMIZATION
The VX-7R has six types of S- (Signal Strength) and TX Power Meter symbol formats
available. You may change the default setting to any of the available symbols.
1. Press the key, then press the
2. Rotate the DIAL to select the Menu Item labeled (Display
Setup #8: METER SYMBOL).
3. Press the key to enable modification of this Menu
Item.
4. Press the or
S1:
S2:
S3:
S4:
S5:
CHR:
5. When you have made your selection, press the PTT key to save the new setting and
exit to normal operation.
The S- and PO Meter Symbol may be changed to appear in the "Main" band
and "Sub" band locations separately.
Modification of the Default the S-and TX Power Meter Symbol
The default "
several other symbols, if desired.
Here's how to replace the default meter symbol:
1. Recall the last meter type, described previously.
2. Press the key to enable modification of this Menu Item.
3. Rotate the DIAL one click clockwise, then press the
the character in the first digit.
Example 1: Press the
ing letters, numbers, and special symbols).
Example 2: Press the
ters: A à B à C à a à b à c à 2
4. Rotate the DIAL to move to the next digit.
5. Repeat previous steps 3 and 4 as necessary to complete (up to 8 characters).
6. When you have made your choice, press the
your selection and exit to normal operation.
You can create an original font, as described in the next column.
76
S- TX P
AND OWER
key to select the desired meter symbol type.
" symbol which is used for last meter type may be replaced by
or key to select any of 61available characters (includ-
key repeatedly to toggle among the seven available charac-
M S
ETER YMBOLS
key to enter the Set mode.
/
key, then press the PTT key to save
VX-7R O
key or keypad to select
M
PERATING ANUAL