Selecting The Wave Form Display; Selecting The Unit Of Temperature Display; Selecting The Unit Of Atmospheric Pressure Meter (Barometer); Correcting The Atmospheric Pressure Meter (Barometer Offset) - Yaesu VX-7R Operating Manual

S M
ENSOR ODE
Selecting the Wave-Form Display
1. Press the key, then press the
2. Rotate the DIAL to select the Menu Item labeled (Mea-
surements #2: WAVE MONITOR).
3. Press the or
(RX SIGNAL, TX MODULATION, or All).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.
Selecting the Units of Temperature Display
1. Press the key, then press the
2. Rotate the DIAL to select the Menu Item labeled (Mea-
surements #3: TEMP UNIT).
3. Press the or
or °F).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.

Selecting the Unit of Atmospheric Pressure Meter (Barometer)

1. Press the key, then press the
2. Rotate the DIAL to select the Menu Item labeled (Mea-
surements #4: BARO UNIT).
3. Press the or
mbar/mmHg/inch).
4. Press the PTT key momentarily to save the new setting and exit to normal operation.

Correcting the Atmospheric Pressure Meter (Barometer Offset)

1. Press the key, then press the
2. Rotate the DIAL to select the Menu Item labeled (Measurements #5: BARO OFF-
SET).
3. Press the key to enable setting of this Menu Item.
4. Press the key to indicate the barometer data in "hpa"
units.
5. Press the or
value in the "hpa" units.
6. Press the key to save the new setting.
7. Press the PTT key momentarily to exit to normal operation.
70
S M
ENSOR ODE
key to enter the Set Mode.
key to select the desired wave form
key to enter the Set Mode.
key to select the preferred unit (°C
key to enter the Set Mode.
key to select the preferred unit (hpa/
key to enter the Set Mode.
key to adjust the VX-7R display to the calibrated barometer
O
PTIONS
VX-7R O
PERATING
M
ANUAL