Hyper Memory Operation - Yaesu VX-7R Operating Manual

The VX-7R usually stores, into memory, the operating frequency and some aspects of
operating status (such as CTCSS/DCS data, repeater shift, power level etc.). However, the
"Hyper Memory" Mode allows you to store the total current configuration of the radio into
a special "Hyper" memory bank.
For example, a Hyper Memory location may store the frequencies of both the "Main" and
"Sub" bands, plus Spectrum Scope operational status, Scanning features, etc.
Hyper Memory Storage
1. Set up the transceiver according to the desired configuration, including parameters
such as Spectrum Scope operation, PMS scanning, etc.
2. Press and hold in the numeric key (
Memory channel into which you wish to store this configuration, for 2 seconds.
In order to prevent accidental storage, the Hyper Memory Storage feature may
be locked out via Menu Item ( Basic Setup #14 HYPER WRITE ) .
Hyper Memory Recall
1. Press the key, then press the
2. Rotate the DIAL konb to select the "4 HYP" mode.
3. Press the PTT switch to activate the "Hyper Memory"
mode.
4. Press the appropriate numeric key (
recall the desired Hyper Memory channel.
5. To exit the Hyper Memory mode, recall the Special
Memory Menu (press
to "1 OFF."
VX-7R O
PERATING
H M
YPER EMORY
key, to recall the Special Memory Menu.
+ ), then change its setting
M
ANUAL
M
M
ODE
through ), corresponding to the Hyper
through ) to
M
EMORY ODE
53