EBARA Ego 2 easy Installation And Operating Manual page 37

ETHERNET
Only available in variant Ego 2 (T) easy C.
The pump has a built-in web server which allows you to access your pump directly via an existing Ethernet
connection. The default address for access to the pump is 192.168.0.245/
The web server uses HTML pages to set/view:
Regulation mode settings,
•
regulation parameters (power, RPM, head, flow),
•
• relay settings,
external control inputs settings,
•
current and previews error,
•
• pump statistics (power consumption, run time and other).
MODBUS
Only available in variant Ego 2 (T) easy C.
Pump has built in Modbus client, through which we can access pump information using the RS 485 standard or
ETHERNET (TCP/IP).
Modbus allows us to set and view:
• Regulation mode settings,
• regulation parameters (power, RPM, head, flow),
• relay settings,
• external control inputs settings,
• current and previews error,
• pump statistics (power consumption, run time and other).
RESETTING PUMP TO FACTORY SETTINGS
For resetting the pump to factory settings all three buttons must be held for 5 seconds. This way the pump will
set itself to automatic mode, delete previous height and power settings and unlock setting pump operation (if
locked).
Resetting of communications module needs following steps:
6. Disconnecting power from pump,
7. set the 10-step switch to number 9
8. turning the pump on and off again,
9. setting the 10-step switch to number 1,
10. turning the pump on.
Communications module should now be set to factory settings.
7 This also sets up the right twin pump.
7 (or 8 for left twin pump),
36
36