Advanced Features - Maytronics Dolphin wave 90i User Instructions

• If the robot is OFF - Turn on the remote and wait for 60 seconds until the self-test is completed.
Press the mode selector and use the direction control arrows to control the movement of the robot
around the pool.
NOTE: If the signal bar is blinking
be due to one of the following reasons.
What's wrong
The power supply isn't working
The remote control is not in range
The remote control isn't paired with
your robot
In case of difficulties operating the remote control unit, try to repeat the above steps or contact our Customer
Care team.
*see details in the end of this document

9. ADVANCED FEATURES

In order to activate the advanced features, please download the MyDolphin
Temperature Sensor
This Dolphin robotic pool cleaner has a unique sensor that lets you know the water temperature.
The sensor shows the temperature in Celsius and Fahrenheit.
Degree range: 6°C to 38°C (42.8°F to 100.4°F).
Filter gauge
This feature shows you two levels of filter mode, and how clogged the filter is, due to a load of dirt
or a certain element getting stuck inside the filter.
This is very important for the efficient operation of the filter and its preservation over time.
The feature can be activated through the MyDolphin™ Plus app.
In / Out of water sensor
This feature enables you to know whether the robotic pool cleaner is inside or outside the
pool water.
Before activating this feature, a calibration is needed. To calibrate, please follow the steps as
shown in the app.
Delay start
This feature allows you to start the operation in 1h , 2h or 3h.
You can use this to let the debris sink in, and settle to the pool floor before the robot starts its
cleaning cycle.
or you have lost connection with the power supply, it could
What to do
Make sure the power supply is plugged in
Move closer to your power supply
Make sure the remote control is OFF. Attach the remote control unit to the power supply.
Press simultaneously on both right and left direction control arrows until you hear two
beeps, and the power supply shows a steady BLUE connectivity LED
Plus app.
TM
Wave 90i User Instructions
|
15