Macintosh Ethertalk Network; Quick Install Steps - Xerox DocuPrint N4525 Network Installation Manual

Macintosh EtherTalk Network

Quick install steps

1. Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet.
2.
Check the Configuration Sheet and verify that the EtherTalk is
enabled, the AppleTalk name is correct, the AppleTalk zone is
correct (if used), and the proper connector is enabled. Details are
in the Advanced Features and Troubleshooting Manual.
3.
Use the software installer to load print drivers. Details for this are
found in your printer's CD-ROM.
Select your printer and zone (if used) in the Chooser.
4.
5. Send a print job to the printer.
6.
Check the print job for print-quality. If print-quality problems
exist, use the print-quality section of your printer's Advanced
Features and Troubleshooting Manual to correct the problem.
7. If your print job did not print, see the Troubleshooting section for
your operating system in the Advanced Features and
Troubleshooting Manual to correct the problem.
Quick Network Install Guide
23