Xerox DocuPrint N4525 Network Installation Manual page 40

Dynamic addressing (DHCP)
The TCP/IP address is assigned automatically by the server.
Press Menu Up or Menu Down until you see:
1.
Menus
Ethernet Menu
Press Item Up or Item Down until you see:
2.
Ethernet Menu
IP Address Res
Press Value Up or Value Down until you see:
3.
IP Address Res
DHCP
4. Press Enter.
5. Power off the printer.
6.
Power the printer on and allow time for an IP address to be
assigned by the DHCP server (this time may vary depending on
network traffic).
7. Perform the steps contained in the section of this document
entitled Appendix A: Print the Configuration Sheet.
8. Obtain the TCP/IP address from the Configuration Sheet.
9. Update the lease time, if necessary, depending on your
printer-usage patterns.
Note
If your network is using this protocol to assign TCP/IP
addresses, be aware that the lease on the assigned address
can run out if your printer is taken off the network for longer
than the allocated lease time.
34
DocuPrint N4525 Network Laser Printer