Macintosh Ethertalk/Tokentalk Network; Quick Install Steps - Xerox DocuPrint C55 Install Manual

Macintosh
EtherTalk/TokenTalk
Network

Quick Install Steps

Q U I C K N E T W O R K
1. Install Network Interface Card in printer (if not already
installed). Details are supplied in the installation kit of
the Network Interface Card.
2. Connect appropriate cabling from printer to network.
Details are in this document in the section entitled
Appendix B - Network Cable Connection
3. Print the Print Settings page. Details are in this
document in Appendix A - Print The Print Settings
Page.
4. Check the Print Settings page and verify that EtherTalk
or TokenTalk is enabled, the AppleTalk name is
correct, the AppleTalk zone is correct (if used), and the
proper connector is enabled. Details are in the
DocuPrint C55/C55mp Technical Information
Guide.
5. Use the software installer to load print drivers. Details
for this are found in the DocuPrint C55/C55mp CD-
ROM.
I N S T A L L G U I D E 29