Macintosh Ethertalk Network; Quick Install Steps - Xerox DocuPrint N2825 Install Manual

Macintosh EtherTalk Network

Quick Install Steps

1
Print the Configuration Sheet. Details are in this
document in Appendix A: Print The Configuration
Sheet.
2 Check the Configuration Sheet and verify that EtherTalk
is enabled, the AppleTalk name is correct, the AppleTalk
zone is correct (if used), and the proper connector is
enabled. Details are in the Technical Information Guide.
3
Use the software installer to load print drivers. Details for
this are found in the your printer CD-ROM.
4
Select your printer and zone (if used) in the Chooser.
5
Send a print job to the printer.
6
Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
7
If your print job did not print, see the Troubleshooting
section for your operating system in the Technical
Information Guide to correct the problem.
Macintosh EtherTalk Network
Quick Network Install Guide 33