Communicating With The Network - Xerox DocuColor 2060 Supplementary Manual

Communicating with the network

Client
workstation Operating
hardware system
Sun Solaris **
Microsystems
PC MS-DOS
PC Windows
95, 98, NT
4.0, 2000,
ME
Guide to Submitting Jobs from the Client
DocuPrint and DocuColor 2060 NPS/IPS client overview
For information on XDS Plus software, refer to the Guide to
Job Submission Using XDS Plus. This document is part of
the Xerox Production Print Services series.
• Xerox DigiPath Quick Print software for Windows NT 4.0
provides a series of dialog boxes that you use to select a
document, set up a job ticket, and submit your print job.
In some cases, the workstation can be set up for more than one
method of job submission.
After the print data has been prepared for printing and combined
with print options data—either by the application software or by a
print job submission utility—the data is sent over the network.
DocuPrint supports TCP/IP , AppleTalk, and Novell NetWare
network communications protocols.
The following table lists the client workstations supported by
DocuPrint NPS/IPS, and the networking options and job
submission methods available for each client.
Table 1-1. Workstation reference
Protocol;
Ethernet Translation
connection requirements
Standard TCP/IP;
none
Optional TCP/IP;
Ethernet network
interface card communication
(for example software is required *
3Com 3C503)
Optional TCP/IP or Novell
Ethernet NetWare 3.1x;
interface network
communication
software is required
with TCP/IP (3.1x) *
Job submission method
Print to file, then send using the
lpr command or Xerox Client
Software, provided that the
remote printer is configured as a
Berkeley spooler
Print to file, then send using the
lpr command
Print directly from Xerox driver,
or use Xerox Document
Submission (XDS) or Quick
Print software for Windows. May
be configured to use the lpr
command in some cases.
1-5