Xerox DocuColor 2060 Supplementary Manual page 78

Printing using Xerox utilities and lpr utilities (DOS and UNIX)
3-28
• -C"(<thick=0 | thick=1 | thick=10 | thick=11>)"
Specifies the thicken attribute as follows:
– 0 = do not darken
– 1 = darken all text and images
– 10 = darken bitmaps but not the text/graphics
– 11 = darken all text and images.
• -C"(uncollated)"
Specifies that copies of the job are printed uncollated.
Example: For a three page job with three copies requested,
the output in the stacker would be 1,1,1,2,2,2,3,3,3.
NOTE: If this option is used with PCL copy commands, the
copies of specific pages are uncollated, but copies of the
entire job is collated. Similarly, with PostScript jobs that
specify copies of sets or runs, only the pages in the specific
sets and runs are uncollated, but copies of the entire job is
collated.
• -C"(xshift=<#>)"
Specifies the x (horizontal for portrait USLetter or A4 page)
image shift from the lower left corner of the page towards the
right (in millimeters). Values may be positive (+) or negative
(-).
NOTE: The specified image shift is applied to both front and
back sides of sheets unless -C"(xshiftback=<#>)" is also
specified, in which case the specified image shift is applied to
front sides of sheets only.
• -C"(xshiftback=<#>)"
Specifies the x (horizontal for portrait USLetter or A4 page)
image shift from the lower right corner of pages imaged
towards the left (in millimeters), to be applied to the back
sides of sheets only. Values may be positive (+) or negative
(-).
Guide to Submitting Jobs from the Client