Xerox DocuColor 2060 Supplementary Manual page 61

Guide to Submitting Jobs from the Client
Printing using Xerox utilities and lpr utilities (DOS and UNIX)
– OffsetPerCopy does not apply when copies are
uncollated.
– When stapling is requested, copies are not stapled when
they are uncollated, though the job still prints face-up.
• -verbose
Causes the filename of each submitted document to display
on the workstation as it is sent to the printer controller.
• -weight <gsm>
Specifies the paper weight in grams per square meter (gsm).
• -x2ImageShift <#>
Specifies the x (horizontal for portrait page) image shift from
the lower right corner towards the left of the portrait page (in
millimeters), to be applied to back sides of pages only. Values
may be positive (+) or negative (-).
• -xImageShift <#>
Specifies the x (horizontal for portrait page) image shift from
the lower left corner towards the right of the portrait page (in
millimeters). Values may be positive (+) or negative (-).
NOTE: The specified image shift is applied to both front and
back sides of pages unless -x2ImageShift <#> is also
specified, in which case the specified image shift is applied to
odd pages only.
• -y2ImageShift <#>
Specifies the y (vertical for portrait page) image shift from the
lower right corner towards the top of the portrait page (in
millimeters), to be applied to back sides of pages only. Values
may be positive (+) or negative (-).
• -yImageShift <#>
Specifies the y (vertical for portrait page) image shift from the
lower left corner towards the top of the portrait page (in
millimeters). Values may be positive (+) or negative (-).
NOTE: The specified image shift is applied to both front and
back sides of pages unless -y2ImageShift <#> is also
specified, in which case the specified image shift is applied to
odd pages only.
3-11