Lprm Command - Xerox DocuColor 2060 Supplementary Manual

Example

lprm command

Syntax
Options in DOS
Guide to Submitting Jobs from the Client
Printing using Xerox utilities and lpr utilities (DOS and UNIX)
• +(interval)
Specifies that the system periodically display the contents of
the print queue until it is empty. If you supply a value in
seconds for the interval, the workstation waits the specified
time before displaying the queue contents.
The example below shows the command to display at ten-
second intervals the contents of the print queue submitted by
Susan to the printer "rushmore."
lpr -Prushmore +10 susan
Use the lprm command to remove jobs from the print queue of a
specific virtual printer.
Caution: If you do not specify any options, the lprm command
removes all active jobs with your user name.
NOTE: This command is available only if you are using FTP
software and with standard UNIX lpr on a Sun workstation. See
the lprm command man page for more information.
To remove a print job from a queue, enter the lprm command
and its options on the command line using the following syntax:
lprm <options>
Options are case sensitive. You can enter more than one option
at a time.
• -\?
Displays the usage statement for lprm.
• -S <printer controller>
Specifies that the request to delete be sent to the printer
controller you specify.
• <job ID number>
Removes the job you specify as referred to in the job id
number specified by the lpq command and not the job id
number on the printer controller.
CAUTION
3-33