User Mode 4 (High Power Saver Mode) "U4 - Xerox 721 Operator's Manual

User Mode 4 (High Power Saver Mode) "U4"

Menu
Press [Menu] 4 times
Menu
Menu
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL
When the High Power Saver Mode is enabled, the printer switches
off power to the Printer Fuser Assembly after a predetermined time
of inactivity. If the printer does not receive a print job or a copy job
for the time selected in this mode, the printer will enter the High
Power Saver Mode to save power consumption.
The High Power Saver Mode saves more power than the Low
Power Saver Mode and the recovery time is longer.
If a print or copy job is detected by the printer, the printer will then
enter the Warm up Mode prior to the start of the job to heat the
Fuser Assembly to 178°C.
The green LED Light inside of the Menu Button flashes when the
printer is in a power saver mode.
1. To enter User Mode 4:
Press the [Menu] Key 4 times when the printer is in the Standby
Enter Online
(idle) Mode.
The [Menu] Key lights green and the Status Display indicates "U4."
Flashing on the left side of the display. The time interval is shown
on the right side of the display.
Enter Online
NOTE: Factory default is On and set to 90 minutes.
2. Press [Enter]
The status (on or off) is displayed. If the status is off, High Power
Saver is disabled.
To change the status, press [Enter] and then the [ --> ] Key or the
[ <-- ] Key.
Press [Enter] again to gain access to the time interval.
To change the time, press [ --> ] Key to increase) and [ <-- ] Key to
Enter Online
decrease, then press [Enter] to save the data.
The display value is "minute", and the selectable ranges are 10,
15, 20, 30, 40, 50, 60, 90, 120, 180 and 240.
USER MODES
55