Xerox 721 Operator's Manual page 50

PROBLEM SOLVING
Slit
Cutter
42
7. Trim the lead edge of the roll square to remove any torn or
wrinkled media by using the "Slit" if necessary.
8. Insert the lead edge of the media between the upper and
lower feed rollers and feed an inch of media between the feed
rollers.
9. Roll 3 only: Rotate the lower feed roller by hand until the lead
edge is visible in the center of the viewing hole.
10. Push in the drawer until it is closed and latched.
11. If the leading edge is not sufficiently square, perform the
automatic Initial Cut by pressing the [Select] key to select the
appropriate drawer, and then pressing [Cut] key.
Approximately 9.5" (240mm) media will be cut and fed from
the printer.
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL