Xerox Document Centre 220 Getting Started page 26

NOTE If the scanning operation is not successful, check the Confirmation
Sheet for a message or other information that may be helpful in
identifying the cause of the problem.
Page 2 - 10
by selecting options from the Scan Setups tab on the DC220/
230/332/340ST Touch Screen (for example, Reduce/Enlarge
or Basic Image Quality). Any changes you make from the
Touch Screen apply only to the current job. The template
settings will be restored after the completion of the scan job.
E. Press the [Start] button. After the job is scanned, the
DC220/230/332/340ST files, faxes, and prints the job as
specified in the @default.xst scan template. At completion,
a Confirmation Sheet (if enabled) is printed that describes the
results of the job.
F. Allow approximately one minute for the process to complete
a one-page job. It will take longer if you have scanned
multiple pages. Then check to make sure that the scanned
file has been stored in the designated repository on the file
server.
G. The DC220/230/332/340ST creates a separate TIFF file for
each page it scans. (Unless the Enable Multi-Page TIFF
option is selected, which will create a single TIFF file for a
multi-page document, instead of one TIFF file for each
page.) Pages are numbered sequentially. Files are stored on
the file server, and the directory path is specified within the
job template.
Companion to Getting Started with Scanning Services