Table of Contents
Advertisement
Specifications - JH 26T11 MMD-xxx-Axxx
PRODUCT SPECIFICATIONS - JH 26T11 MMD-xxx-Axxx
TFT Technology:
• High Quality TFT
• Optical Bonding Terchnology
• 25.54 inch viewable image size - Widescreen, Aspect Ratio 16:10
• S-MVA, Active Matrix, Thin Film Transistor (TFT)
• RGB Vertical Stripe
TFT Characteristics:
• Native Resolution
: 1920 x 1200
• Pixel Pitch (RGB)
: 0.2865 (H) x 0.2865 (V) mm
• Response Time
: 8 ms (typical), "gray" to "gray"
• Contrast Ratio
: 1500:1 (typical)
• Light Intensity
: 350 cd/m
• Viewable Angle
: +/- 88 deg. (typical) (Up/Down/Left/Right)
• Active Display Area
: 550.08 (H) x 343.8 (V) mm
• Max Colors
: 16.7 millions
Synchronisation:
Sync Signal:
• Digital separate synchronisation
• Composite synchronisation
• Synchronisation on green.
• Auto detects VGA -> WUXGA, interlaced and non interlaced
• Video Signal
: Analog RGB 0,7Vp-p
: Input Impedance 75 Ohm
Synchronisation Range:
• Horizontal
: 15,0 kHz to 91,1 kHz
• Vertical
: 60 Hz* to 85 Hz
* Recommended for optimum picture quality
Supported Signals:
Resolutions:
• VGA
: 640 x 480 (including 640 x 350)
• SVGA
: 800 x 600 (including 720 x 400)
• XGA
: 1024 x 768
• SXGA
: 1280 x 1024
• UXGA
: 1600 x 1200
• WUXGA
: 1920 x 1200*
* Recommended for optimum picture quality. (60 Hz)
Video Signals (with HATTELAND® Multifunction Cable):
• Interlaced NTSC and PAL/SECAM video
• Composite video
Power Specifications:
Power Supply Options:
• 115&230VAC - 50/60Hz
• 115&230VAC - 50/60Hz + 24 VDC
*Multi-power note: You may connect either AC power or DC power or both. In case
both sources are connected, power will be sourced from the AC input. If AC input is
lost, there will be a uninterrupted switch-over to DC input.
Power Consumption:
Operating
: 122W (TYP) - 185W (MAX)
Typical Type Numbers:
• JH 26T11 MMD-MA1-AOBA
• JH 26T11 MMD-AA1-AOAC
Buzzer-Potmeter-Keypad
MMD-xxx-xxBx
For a full overview, please review our typenumber sheet found on our website:
http://www.hatteland-display.com/pdflink/ind100780-1.php
T E S T I N G / A P P R O V A L S
IEC 60945 4th (EN 60945:2002)
DNV - Det Norske Veritas (pending)
LRS - Lloyd's Register of Shipping (pending)
IND100129-127
2
(typical)
- JH 26T11 MMD-Axx-xxxx
- JH 26T11 MMD-Mxx-xxxx*
= AC/DC, Bonded, Potmeter Controls+Buzzer
= AC, Bonded, Capacitive Touch Screen
Keypad
MMD-xxx-xxAx
This product have been tested / type approved by the following classification societies:
ClassNK - Nippon Kaiji Kyokai (pending)
ABS - American Bureau of Shipping (pending)
Note: All specifications are subject to change without prior notice!
Physical Considerations:
• 635.00 (W) x 499.00 (H) x 101.50 (D) mm
• 25.00" (W) x 19.65" (H) x 4.00" (D)
• Weight: 15 kg (approx)
Signal Terminals:
• DVI-I Signal IN
: 1 x 29p DVI Female (or as RGB IN with adapter)
• RGB Signal IN
: 1 x 15p HD D-SUB (female)
• RGB Signal OUT
: 1 x 15p HD D-SUB (female) - Clone of RGB IN**
• Multifunction
: 1 x 160p D-SUB (female) - Also see table below
• USB I/O
: 1 x TYPE B Conn. (female) Reserved for future use
• AC Power IN
: 1 x Std IEC Inlet
• DC Power IN
: 1 x 2p D-SUB Connector (male) - Amphenol FCC17
• AC Power OUT
: 1 x Std IEC Outlet (5A Max)
**Tested at recommended resolutions. The RGB output signal is at same resolution
and sync as the RGB input. The output is working even if the display unit is turned off,
but power cable/supply must be connected/provided.
HATTELAND® Multifunction Cable:
The factory standard cable is delivered with the following connectors.
Standard cable length is 30cm. Art: #1=VSD100692-4 / #2=VSD100692-3
• COM1
#1
• Composite Video IN
• COM1
#2
• Composite Video IN
• COM Touch
Customized cables are possible to support more built-in signals, like: RS-232,
RS-485, RS-422/RS-485, Buzzer, ON/OFF, Touch (RS-232 or PS/2), 1 x S-Video IN, 3 x
Composite Video IN, Remote External User Controls, Alternative Keypad interface (i2c)
and reserved for other signals. Custom cable lengths can be manufactured.
User Controls:
On front bezel - Keypad control (IP66) xxx-xxAx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (up/down - push buttons),
• Hotkeys (left/right - push buttons)
• Mode Status Red/Green Illuminated LED-Ring Indicator
On front bezel - Potmeter control (IP66) xxx-xxBx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (rotary control) and Hotkeys (left/right - push buttons)
• Mode Status Red/Green Illuminated LED-Ring Indicator and
• Speaker / Buzzer
Environmental Considerations:
• Operating
: Temperature -15 deg. C to +55 deg. C
- Humidity up to 95%
• Storage
: Temperature -20 deg. C to +60 deg. C
- Humidity up to 95%
• IP Rating
: Protection (EN60529): IP66 front - IP20 rear
• Compass Safe Dist. : JH26T11MMD-xxx-xxxx - Std: 125cm Steering: 80cm
Safety Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
Available Accessories:
• Cables
= Custom Multifunction Cable to support more signals
• JH 26BRD STD-A1 = Mounting Bracket EN6095 Tested
• JH 26TBR STD-A1 = Mounting Bracket
• JH MMDRO STD-A1 = Rotary Bracket
• JH 26TSV STD-A1 = Sun Visor
• JH 26VED STD-A1 = Vesa Bracket
• JH 26TWC STD-A1 = Water Cover
*Please see user manual for drawings/measurements.
Factory Options:
• Color Calibrated models (ECDIS)
• Capacitive Touch Screen / Optical Bonding Technology
& C E R T I F I C A T E S
GL - Germanischer Lloyd (pending)
BV - Bureau Veritas (pending)
55
INB100036-1 (Rev 21)
: 1 x 9p D-SUB (female) - RS232
: 3 x BNC (female)
: 1 x 9p D-SUB (female) - RS232
: 3 x BNC (female)
: 1 x 9p D-SUB (female) - For touch screen
2/2
Advertisement
Table of Contents
