Specifications - Jh 19T14 Mmd-Xxx-Sxxx - Hatteland JH 15T17 MMD-A Series User Manual

Maritime multi display models
Table of Contents

Advertisement

Specifications - JH 19T14 MMD-xxx-Sxxx

PRODUCT SPECIFICATIONS - JH 19T14 MMD-Mxx-Sxxx
TFT Technology:
• High Quality SHARP TFT
• 19.0 inch viewable image size
• Active Matrix, Thin Film Transistor (TFT)
• MVA Premium™ Technology
TFT Characteristics:
• Pixel Number
: 1280 x 1024
• Pixel Pitch (RGB)
: 0.294 (H) x 0.294 (V) mm
• Response Time
: 12 ms (typical), "black" to "white"
• Contrast Ratio
: 900:1 (typical)
• Light Intensity
: 300 cd/m2 (typical)
• Viewable Angle
: +/- 85 deg. (typical) (Up/Down/Left/Right)
• Active Display Area
: 376.32 (H) x 301.056 (V) mm
• Max Colors
: 16.7 millions
Synchronisation:
Sync Signal:
• Digital separate synchronisation
• Composite synchronisation
• Synchronisation on green.
• Auto detects VGA -> WUXGA, interlaced and non interlaced
• Video Signal
: Analog RGB 0,7Vp-p
: Input Impedance 75 Ohm
Synchronisation Range:
• Horizontal
: 15,0 kHz to 91,1 kHz
• Vertical
: 60 Hz* to 85 Hz
* Recommended for optimum picture quality
Supported Signals:
Resolutions:
• VGA
: 640 x 480 (including 640 x 350)
• SVGA
: 800 x 600 (including 720 x 400)
• XGA
: 1024 x 768
• SXGA
: 1280 x 1024*
• UXGA
: 1600 x 1200
• WUXGA
: 1920 x 1200
* Recommended for optimum picture quality. (60 Hz only)
Video Signals (with HATTELAND® Multifunction Cable):
• Interlaced NTSC and PAL/SECAM video
• Composite video
Power Specifications:
Multi-power Supply:
• 115&230VAC - 50/60Hz + 24 VDC
Note: You may connect either AC power or DC power or both. In case both
sources are connected, power will be sourced from the AC input. If AC input
is lost, there will be a uninterrupted switch-over to DC input.
Power Consumption:
Operating
:
50W (TYP) - 60W (MAX)
Typical Type Numbers:
• JH 19T14 MMD-MA1-SAAA
• JH 19T14 MMD-MA1-SAAC
• JH 19T14 MMD-MA1-SOBA
Buzzer-Potmeter-Keypad
MMD-Mxx-SxBx
For a full overview, please review our typenumber sheet found on our website:
http://www.hatteland-display.com/pdflink/ind100780-1.php
T E S T I N G / A P P R O V A L S
IEC 60945 4th (EN 60945:2002)
DNV - Det Norske Veritas (Pending)
CCS - China Classification Society (Pending)
Slim Frame/JH 17T02 replacement
IND100129-100
- JH 19T14 MMD-Mxx-Sxxx
= Standard, Keypad controls only
= Standard, Capacitive Touch Screen
= Standard, Bonded, Potmeter Controls, Buzzer
Keypad
MMD-Mxx-SxAx
This product have been tested / type approved by the following classification societies:
ClassNK - Nippon Kaiji Kyokai
ABS - American Bureau of Shipping (Pending)
LRS - Lloyd's Register of Shipping
Note: All specifications are subject to change without prior notice!
Physical Considerations:
• 460.00 (W) x 400.00 (H) x 82.00 (D) mm
• 18.11" (W) x 15.75" (H) x 3.23" (D)
• Weight: 10 kg (approx)
Signal Terminals:
• DVI-I Signal IN
: 1 x 29p DVI Female (or as RGB IN with adapter)
• RGB Signal IN
: 1 x 15p HD D-SUB (female)
• RGB Signal OUT
: 1 x 15p HD D-SUB (female) - Clone of RGB IN**
• Multifunction
: 1 x 160p D-SUB (female) - Also see table below
• USB I/O
: 1 x TYPE B Conn. (female) Reserved for future use
• AC Power IN
: 1 x Std IEC Inlet
• AC Power OUT
: 1 x Std IEC Outlet (5A Max)
• DC Power IN
: 1 x 2p D-SUB Connector (male) - Amphenol FCC17
**Tested at recommended resolutions. The RGB output signal is at same resolution and sync as the
RGB input. The output is working even if the display unit is turned off, but power cable/supply must
be connected/provided.
HATTELAND® Multifunction Cable:
The factory standard cable is delivered with the following connectors.
Standard cable length is 30cm. Art: #1=VSD100692-4 / #2=VSD100692-3
• COM1
#1
• Composite Video IN
• COM1
#2
• Composite Video IN
• COM Touch
Customized cables are possible to support more built-in signals, like: RS-232, RS-485, RS-422/RS-485,
Buzzer, ON/OFF, Touch (RS-232 or PS/2), 1 x S-Video IN, 3 x Composite Video IN, Remote External
User Controls, Alternative Keypad interface (i2c) and reserved for other signals. Custom cable lengths
can be manufactured.
User Controls:
On front bezel - Keypad control (IP66) xxx-xxAx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (up/down - push buttons)
• Hotkeys (left/right - push buttons)
• Mode Status Red/Green Illuminated LED-Ring Indicator
On front bezel - Potmeter control (IP66) xxx-xxBx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (rotary control) and Hotkeys (left/right - push buttons)
• Mode Status Red/Green Illuminated LED-Ring Indicator
• Speaker / Buzzer
Environmental Considerations:
• Operating
: Temperature -15 deg. C to +55 deg. C
- Humidity up to 95%
• Storage
: Temperature -20 deg. C to +60 deg. C
- Humidity up to 95%
• IP Rating
: Protection (EN60529): IP66 front - IP20 rear
• Compass Safe Dist.: JH 19T14 MMD-Mxx-Sxxx Std: 65cm Steering: 35cm
Safety Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
Available Accessories:
• Cables
= Custom Multifunction Cable to support more signals
JH 19TWC STD-C1= Water Cover
JH 19TBR STD-B1 = Mounting Bracket
JH 19BRD STD-B1 = Mounting Bracket EN60945 RAL 9011
• JH MMDROSTD-A1= Rotary Bracket
JH 19VED STD-B1 = VESA Bracket
JH 19TSV STD-B1 = Sun Visor
• JH 17TAP STD-A1 = Adapter frame for 19" RACK
*Please see user manual for drawings/measurements.
Factory Options:
• Resistive* or Capacitive Touch Screen / Optical Bonding Technology*
• Color Calibrated models (ECDIS)
*Note that all 19 inch with resistive touch screens can not be combined with bonding.
& C E R T I F I C A T E S
GL - Germanischer Lloyd (Pending)
BV - Bureau Veritas
49
INB100036-1 (Rev 21)
: 1 x 9p D-SUB (female) - RS232
: 3 x BNC (female)
: 1 x 9p D-SUB (female) - RS232
: 3 x BNC (female)
: 1 x 9p D-SUB (female) - For touch screen
2/2

Advertisement

Table of Contents
loading

Table of Contents