Assa Abloy Corbin Russwin IN120 Installation Instructions Manual page 20

IN120 / IN220
FE6600/BL6600/MP6600 Series
Multi-point Lock
Installation Instructions
6 Installation Instructions (Continued)
j
Installation of Connectors, continued
Note: If you are installing IN220 (PoE):
10. Pull 5-1/2" of Ethernet cable from hole. Strip
the cable jacket back 3-1/2".
11. Separate (untwist) and straighten (8) Ethernet
wires before carefully feeding through ferrite
bead. See Figure 8E.
12. Crimp RJ45 (male) connector on end of wires.
For more detail, refer to Section 5A Frame
Harness Installation.
k
Controller Installation
CAUTION - Do not allow debris to enter connector contacts.
Fig. 9A
Apply the grease to the connector and the recessed area surrounding the connector.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019-2021 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Before you install the controller, apply diaelectric grease to the connector
located on the back of the controller . See Figure 9B . Do not allow debris to
enter the connector contacts .
Fig. 8E
*Be sure to apply grease to connector and recessed area
surrounding connector
Fig. 9C
Fig. 9B
20
FM455 04/21