Assa Abloy Corbin Russwin IN120 Installation Instructions Manual page 11

Hide thumbs Also See for Corbin Russwin IN120:

IN120 / IN220

FE6600/BL6600/MP6600 Series

Multi-point Lock

Installation Instructions

IN220 (PoE) Wiring & Illustration, continued

PoE Door Harness

Order of installation may vary. Refer to appropriate sections for instructions.

Hinge-side harness connectors:

• 4-pin male Molex connector

• 6-pin male Molex connector with ground wire

Lock-side harness connectors:

• Ring terminal

• Male RJ45 connector (crimped after cable is fed through door)

Notes:

Connectors go on only one way. They cannot be plugged to incorrect position.

Do not force and do not offset connectors.

Be sure they are completely seated (flush).

PoE Lock

Order of installation may vary.

Refer to appropriate sections for instructions.

1. Prop door open

2. Using the ring terminal, carefully route the assembly

through the door channel toward lock.

Note: Do not terminate PoE harness (with RJ45 M)

until the cable has been routed through the door and

the inside mounting plate assembly. See Section 6J -

Installation of Connectors.

For installation assistance contact Corbin Russwin

1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com

or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.

IN220 PoE Lock

FM455 04/21

Table of Contents

Corbin russwin in220