Xerox 5750 Service Manual page 32

Status
Code
10-366, 367 The control logic sensed that the Heat Roll temperature exceeded 180˚.
Initial action:
Check the Heat Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the
Thermistor contacts the Heat Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-368 The control logic sensed an open circuit from the Pressure Roll control thermistor.
Initial action:
Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where
the Thermistor contacts the Pressure Roll (REP 5.37).
If the problem still exists:
Place a service call.
10-369 The control logic sensed an open circuit from the Pressure Roll overheat thermistor.
Initial action:
Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where
the Thermistor contacts the Pressure Roll (REP 5.37).
If the problem still exists:
Place a service call.
Fault Code Procedures
Description/Direction
5/98
2-32 5750 DocuCare Service Manual