Xerox 5750 Service Manual page 24

Status
Code
08-168 The control logic sensed a timing problem from the Misstrip Jam Sensor.
Initial action:
Ensure that there is no paper jammed at the CTR (Charged Transfer Roll) Cleaner.
Clean Tray 1, 2, 3 or 4 Feed, Retard, Nudger, Preregistration and Registration Rolls with a damp cloth
(water) (REP 5.22) (REP 5.24).
Clean the CTR (Charged Transfer Roll) Film with a dry cloth (REP 5.10).
Check for excessive wear, damage or proper installation of the Stripper Finger.
Check for a broken or arcing Transfer Corotron (TC) wire (REP 5.17).
If the problem still exists:
Place a service call.
08-169 The control logic sensed a timing problem from the Stripper Jam Sensor.
Initial action:
Ensure that there is no paper jammed at the CTR (Charged Transfer Roll) Cleaner.
Clean Tray 1, 2, 3 or 4 Feed, Retard, Nudger, Preregistration and Registration Rolls with a damp cloth
(water).
Clean the CTR (Charged Transfer Roll) Film with a dry cloth (REP 5.10).
Check for excessive wear, damage or proper installation of the Stripper Finger.
Check for a broken or arcing Transfer Corotron (TC) wire (REP 5.17).
If the problem still exists:
Place a service call.
Fault Code Procedures
Description/Direction
5/98
2-24 5750 DocuCare Service Manual