Xerox 5750 Service Manual page 11

Status
Code
05-111 The control logic sensed a timing problem with the ADF Registration Off Jam Check.
Initial action:
Check the paper path for pieces of ripped paper or other foreign objects.
Inspect the Platen Belt for contamination, excessive wear or damage.
Check the Platen Glass for contamination (REP 5.2).
Open and close the ADF left cover. Check for binding or other mechanical problems with the left cover.
Observe the UI and make sure the customer message to close the left cover appears in a timely fashion.
If the problem still exists:
Place a service call.
05-115, 116 The control logic sensed a timing problem with the ADF Exit Sensor On Jam Check (05-115) or the ADF Exit Sensor
Off Jam Check (05-116).
Initial action:
Check the exit paper path for pieces of ripped paper or other foreign objects.
Inspect the Platen Belt for contamination, excessive wear or damage.
Check the Platen Glass for contamination (REP 5.2).
Verify that the Exit Chute Cover is installed correctly.
Check the Static Eliminator for damage and correct installation.
NOTE : Certain types of coated originals may leave a residue on the platen glass when heated by the expo-
sure lamp. This residue may cause the original to stick to the platen glass and not feed out of the ADF To
avoid this problem make only a few copies of coated originals at a time or do not use the ADF when copying
coated originals
If the problem still exists:
Place a service call.
5750 DocuCare Service Manual
Description/Direction
5/98
2-11 Fault Code Procedures