Xerox 5750 Service Manual page 21

Status
Code
Tray Paper The control logic has sensed that the the paper size is not being detected correctly.
Size
Initial action:
Sensing for
Go to the Paper Tray which was selected on the Control Panel and verify that the Paper Size Indicator is set
Tray 1, Tray
to the correct paper size that is loaded in the Paper Tray.
2, Tray 3,
Tray 4, or
Go to the Paper Tray which was selected on the Control Panel and verify that the paper is loaded correctly.
the Bypass
NOTE : Check for obvious damage, missing or broken Drive Motor gear assemblies and drive belts. These
Tray
items may cause a sensor failure to be displayed as an operator error message.
If the problem still exists:
Place a service call.
08-105, The control logic sensed a timing problem from the Feed Out sensor for Tray 1 (08-105), Tray 2 (08-110), Tray 3 (08-
110, 115, 115) or Tray 4 (08-120).
120
Initial action:
For the appropriate tray, check the Tray Feed Out Sensor actuator for freedom of movement and proper
installation.
Check for proper installation of the appropriate Paper Guide.
For the appropriate tray, check the Feed Sensor, Nudger, Retard and Feed Rolls shaft, for cleanliness,
damage and excessive wear.
Clean the Feed, Retard and Nudger Rolls with a damp cloth (water) (REP 5.22) (REP 5.24).
Fan the paper or replace the paper with a new ream of paper.
If the problem still exists:
Place a service call.
5750 DocuCare Service Manual
Description/Direction
5/98
2-21 Fault Code Procedures